Hypertherm EcoSift, Operator'S Manual

Page: 163 / 188

Inst
allati
on
Installation
EcoSift Operator Manual 809500 163
Test the motor rotation
This procedure is sometimes called a bump start. Turn
ON
the motor briefly to see which direction that the shaft
and the counterweight disk spin.
1. Remove the small panel on the lower drum housing of the primary shaker to see the lower counterweights.
2. Turn
ON
the electric power supply.
3. Turn the electrical disconnect knob to
I O
N
.
WARNING
Rotation
To repair or maintain the motor, disconnect the power source from the motor and any accessory
devices and let the motor to come to a complete stop.
WARNING
Work that requires opening the electrical enclosure or removing covers or panels from the EcoSift
unit must be done only by an approved technician.
WARNING
Installation, maintenance, and repairs to the electrical and plumbing systems must meet national
and local electrical and plumbing codes. This work must be done only by an approved technician.
WARNING
To decrease the risk of serious injuries or death, wear approved protection and obey safety
recommendations when working with electricity.
WARNING
Working on this system while it is energized can cause a potentially dangerous situation, which, if
not prevented, can cause serious injuries or death.
Use a lock-out program when personnel do service or maintenance operations on machines that are
capable of exposing a person to hazardous energy from unexpected energization, startup, or release
of stored energy. This energy can be from electric, hydraulic fluid, or water sources.