HygroMatik Basic-DS, Manual

Page: 35 / 102

SPA
Page 35
6.2 Explanation of Parameters
Parameters D1, D2, D3 and G2 may also be modified in User Mode;
but the new settings will be lost when the unit is switched off.
6.2.1 Steam Bath Functions
6.2.1.1 Steam Bath Mode D0 (Operating Mode)
Possible Settings: -with status
-without status
The DS-Control is designed for use with steam baths. Additional infor-
mation (operational conditions) regarding steam generation may be
useful for maintenance and initial start-up. If the operational mode is
set to “with status”, an operational condition is displayed in the 1st line
of the display (also see illustration in Section “Operational Conditions
(Dependent on Unit Type)” and readout values are displayed in the
2nd and 3rd lines of the display (also see illustration in Section “Read-
out Values” ).
H11 Counter
Partial Blow-down
0 - 999 kg Parameter Setting/
Blow-Down Parameters
010
H12 Time
Partial Blow-down
0-255 [s] Parameter Setting/
Blow-Down Parameters
010
P1 Output limitation 25% - 100% Parameter Setting/
Control Parameters
none
P2 Maintenance interval 0,1 - 25,5 [10³ kg] Parameter Setting/
Maintenance Parameters
010
P3 Reset maintenance
interval Yes / No Parameter Setting/Mainte-
nance Parameters 010
P5 Address 1 - 999 Parameter Setting/ Data
Parameters none
P6 Operation timer dddd:hh Parameter Setting/ Data
Parameters none
P11
reset main contactor
interval Yes / No
Parameter Settings/Main-
tenance Parameters 010
T0 Timer mode
(only with Comfort Plus)
Switch On and Switch Off
Times
(weekly, daily, off)
Parameter Setting/
Time Clock
010
U5 Pumping without K1 Yes (Main Contactor=off)
No (Main Contactor=on)
Parameter Setting/
Blow-Down Parameters
010
U6 Operating mode 1-step
internal PI-Controller
Parameter Setting/
Control Parameters
010
* Only when an internal PI-Controller is activated.
Para-
meter
Designation Possible Settings in Menu / Submenu Access
Code
Please note