MCS 1000 Series
Content
HYDAC FILTER SYSTEMS GMBH
en(us)
Page 4 / 76
BeWa MCS1000 3435427f V130 en-us 2012-06-15.doc
2012-06-15
Connecting MCS15xx via flange adapter plate (accessories) .............................. 34
Connecting MCS15xx via SAE 4" per ISO 6162-1 (4xM16) ................................. 35
MCS hydraulic installation ....................................................................................35
Flow rate, differential pressure
p
and viscosity
characteristics ..................... 36
Electrical connection of the MCS..........................................................................38
Plug pin assignment .............................................................................................38
Connection cable - Assignment / Color coding..................................................... 39
Connecting cable wires.........................................................................................40
Using switching outputs........................................................................................41
Switching output - FE.NFE (factory setting)..........................................................41
Switching output - ALL.RDY .................................................................................41
Switching logic "active low" .................................................................................42
Switching on sensors............................................................................................42
Example: Operation - 1 particle detected..........................................................42
Example: Operation - no particle detected........................................................43
Example: Operation - several particles detected ..............................................43
Switching logic "active high"................................................................................44
Switching on the sensor........................................................................................44
Example: Operation - 1 particle detected..........................................................44
Example: Operation - no particle detected........................................................45
Example: Operation - several particles detected ..............................................45
Switching output "Device Ready" ........................................................................46
Parameterizing MCS / reading off measured values ...........................................47
Connecting MCS 1000 with SMU 1200 ................................................................47
Connecting MCS with CSI-D-5 (Condition Sensor Interface) ............................... 48
Connecting MCS to HMG 3000 ............................................................................49
Evaluating measurement results ..........................................................................50
Menu structure .......................................................................................................51
PowerUp Menu .......................................................................................................52
MODE - select operating mode ............................................................................52
S.TIME - Set storing interval.................................................................................52
SEL.COM - Set protocol .......................................................................................52
ADRESS – Set bus address .................................................................................52
DFAULT - Reset to factory setting........................................................................52
CANCEL - cancel without saving..........................................................................53
SAVE - save changes...........................................................................................53
Measuring menu.....................................................................................................53
DSPLAY - Show measured variable.....................................................................53
SWT.OUT - Set switching output..........................................................................54
SWT.LOG - Set logic at the switching output .......................................................55
SWT.PLS - Set pulse length at the switching output ............................................55
CANCEL - cancel without saving..........................................................................55
SAVE - Save changes ..........................................................................................55
Error analysis / remedy..........................................................................................56
