Husqvarna TC 50, Owner'S Manual

Page: 51 / 137

11 SERVICE WORK ON THE CHASSIS
49
H01857-10
–
Position the upper triple clamp with the handlebar.
–
Mount nut
4
, but do not tighten it yet.
0 0 0 5 5 0 0 5 5
S01480-11
(TC 50)
–
Position the fork legs.
Bleeder screws
5
are positioned toward the rear.
Info
The second milled groove (from the top) must be
flush with the top edge of the upper triple clamp.
H01858-10
–
Tighten screws
6
.
Guideline
Screw, bottom
triple clamp M8 15 Nm (11.1 lbf ft)
H01859-10
–
Tighten nut 4 .
Guideline
Nut, steering
head M20x1.5 10 Nm (7.4 lbf ft)
Nut, steering
head M20x1.5 9 Nm (6.6 lbf ft)
Only applies when
using:
Holding wrench for
steering head bearing
(45229050000)
–
Position the fuel tank breather
7
in the steering stem.
H01859-11
–
Tighten screw
8
.
Guideline
Screw, top triple
clamp M8 20 Nm (14.8 lbf ft)
–
Using a plastic hammer, tap lightly on the upper triple
clamp to avoid stresses.
–
Tighten screws
9
.