Husqvarna TC 50, Owner'S Manual

Page: 103 / 137

15 TUNING THE ENGINE
101
15.3 Adjusting the play in the throttle cable
Preparatory work
–
Check the installation position of the throttle grip. ( p. 100)
–
Remove the seat. ( p. 63)
–
Remove the left side cover. ( p. 59)
–
Remove the right side cover. ( p. 57)
–
Turn the knurled screw on the fuel tap all the way clockwise.
–
Remove the fuel tank. ( p. 53)
–
Check the throttle cable routing. ( p. 74)
V00543-10
Main work
–
Move the handlebar to the straight-ahead position.
–
Push back sleeve
1
.
–
Ensure that the throttle cable sleeve is pushed all the way
into barrel adjuster
2 .
–
Loosen nut
3
.
400192-11
–
Turn barrel adjuster
2
so that there is play
A
in the throttle
cable at the throttle grip.
Guideline
Play in gas throttle cable 3 … 5 mm (0.12 … 0.2 in)
–
Tighten nut
3
.
–
Slide on sleeve
1
.
Finishing work
–
Install the fuel tank. ( p. 54)
–
Install the left side cover. ( p. 60)
–
Install the right side cover. ( p. 58)
–
Mount the seat. ( p. 63)
–
Check the play in the throttle cable. ( p. 100)
15.4 Carburetor - idle (TC 50)
H00078-10
The idle setting of the carburetor has a big influence on the start-
ing behavior, stable idling, and the response to throttle opening.
This means that an engine with a correctly set idle speed is eas-
ier to start than if the idle speed is set wrongly.
Info
The carburetor and its components are subject to
increased wear caused by engine vibration. Wear can
result in malfunctioning.