Husqvarna TC 50, Owner'S Manual

Page: 55 / 137

11 SERVICE WORK ON THE CHASSIS
53
Guideline
Nut, steering
head M20x1.5 10 Nm (7.4 lbf ft)
Nut, steering
head M20x1.5 9 Nm (6.6 lbf ft)
Only applies when
using:
Holding wrench for
steering head bearing
(45229050000)
–
Using a plastic hammer, tap lightly on the upper triple
clamp to avoid stresses.
–
Tighten screw
3
.
Guideline
Screw, top triple
clamp M8 20 Nm (14.8 lbf ft)
–
Tighten screws
2
.
Guideline
Screw, top triple
clamp M8 20 Nm (14.8 lbf ft)
–
Position the fuel tank breather
1
in the steering stem.
Finishing work
–
Check play of steering head bearing. ( p. 51)
–
Remove the motorcycle from the lift stand. ( p. 43)
11.13 Greasing the steering head bearing
H02387-01
–
Remove the lower triple clamp. ( p. 48)
–
Install the lower triple clamp. ( p. 48)
11.14 Removing the fuel tank
Danger
Fire hazard Fuel is highly flammable.
The fuel in the fuel tank expands when warm and can escape if overfilled.
–
Do not refuel the vehicle in the vicinity of open flames or lit cigarettes.
–
Switch off the engine for refueling.
–
Make sure that no fuel is spilled; particularly not on hot parts of the vehicle.
–
If any fuel is spilled, wipe it off immediately.
–
Observe the specifications for refueling.