Husqvarna SM 50 / 2011, Workshop Manual

Page: 46 / 150

D.22
H02072
6
7
6
H02073
3
1
2
1
2
Ed. 01-09-2010
SETTINGS AND ADJUSTMENTS
- Loosen the two bolts (6) securing steering head onto fork legs (use a 6 mm
Allen wrench);
- Screw ring nut (7) with a 27 mm lowered wrench to the torque of 10 Nm, 3
Kgm, 7.38 ft/lb then increase until reaching a soft steering, without clearan -
ce;
- Tighten steering head tube nut (5) to 30 Nm, 3 Kgm, 22.13 ft/lb;
- Tighten the two bolts (6) on the steering head to 25 Nm, 2.5 Kgm, 18.44 ft/
lb.
- Refit all the disassembled parts in reverse order, making sure to refit clamps
(3) in the same direction, and tightening screws (2) to 25 Nm, 2.5 kgm, 18.44
ft/lb, so that the front and rear distance between upper and lower clamp is
alike.
After having refit handlebar, make sure that throttle cable and front brake
pipe are in the correct position.
Handlebar position change
Handlebar position can be changed to better suit your riding style. To perform
this adjustment, remove the retaining screws (3) on upper clamp (1) and lower
clamp (2).
- Rotate lower clamps by 180° to move handlebar position forward or backward
(approx. 10 mm- 0.04 in.) compared to the original position.
Once finished, tighten the two screws (3) to 25 Nm, 2.5 Kgm, 18.44 ft/lb