Husqvarna Royale, User Manual

Page: 27 / 144

A
B
C
D
2:7
2 Set Up
BOBBIN WINDING
BOBBIN WINDING THROUGH THE
NEEDLE
Make sure that the presser foot and the needle are in the up
position.
1. Place an empty bobbin on the bobbin spindle on
WKHWRSRI WKHPDFKLQH7KHEREELQRQO\ÀWVRQ
one way, with the logo facing up. Use only original
+8649$51$9,.,1*
® bobbins.
2. Thread the machine with the main spool pin in the
horizontal position.
Note: If the thread spool is too large to be in horizontal position,
wind the bobbin as described under “Winding Specialty Threads”
below.
%ULQJWKHWKUHDGXSIURPWKHQHHGOHXQGHUWKHSUHVVHU
foot and up to the right through
WKUHDGJXLGH$
Note: Use a metal presser foot when bobbin winding from the
needle.
4. Guide the thread through the hole in the bobbin from
the inside to the outside.
5. Push the
EREELQZLQGLQJOHYHUWRZDUGVWKHEREELQ
WRZLQG$SRSXSPHVVDJHDSSHDUVRQVFUHHQ7R
adjust winding speed drag the slider with your stylus.
6WRSDQGVWDUWWKHEREELQZLQGLQJZLWKWKHRQVFUHHQ
ROGWKHHQGRI WKHWKUHDGÀUPO\ZKHQ
VWDUWLQJWRZLQG2QFHWKHEREELQEHJLQVWRZLQGFXW
the excess thread.
Note: It is important that you cut the thread end close to the bobbin.
:KHQWKHEREELQLVIXOOWKHEREELQZLQGHUOHYHUZLOO
PRYHEDFNDQGWKHZLQGLQJZLOOVWRSDXWRPDWLFDOO\7KH
pop-up message closes.
5HPRYHWKHEREELQDQGFXW
the thread using the bobbin winding thread cutter.
WINDING SPECIALTY THREADS
We do not recommend winding speciality threads such as
´LQYLVLEOHµRURWKHU
stretchy threads, metallic or
ÁDW
metallic
threads through the needle.
$OZD\VZLQGWKHVHWKUHDGVDWPLQLPXPVSHHG
1. Place an empty bobbin on the bobbin spindle at
WKHIURQWRI WKHPDFKLQH7KHEREELQRQO\ÀWVRQ
one way, with the logo facing up. Use only original
+8649$51$9,.,1*
® bobbins.
2. Place the large spool cap and a felt pad under the spool
RQWKHPDLQVSRROSLQVHWLQWKHYHUWLFDOSRVLWLRQ
%ULQJWKHWKUHDGRYHUWKH
Pre-Tension Thread guide
%DQGGRZQDURXQGWKHWKUHDGWHQVLRQGLVF&WKHQ
through
WKUHDGJXLGH'DVLOOXVWUDWHG
6HH%REELQ:LQGLQJWKURXJKWKHQHHGOHVWHS
Note: When using earlier version of HUSQVARNA VIKING ®
bobbins that do not have a hole, wind a few turns of thread clockwise
on the bobbin to get started.