Husqvarna Royale, User Manual

Page: 124 / 144

8:14
8 Embroidery Stitch-Out
Cut thread end
$IWHUFKDQJLQJWKHWKUHDGWKHPDFKLQHZLOOVHZDIHZ
stitches and then stop so you can cut the thread end.
Note: When Automatic Jump Stitch Trim is selected in the SET
Menu, the thread end will be cut automatically. Simply remove the
thread tail that has been cut.
(PEURLGHU\LVÀQLVKHG
$SRSXSPHVVDJHDQGVRXQGLQIRUPV\RXWKDW\RXU
HPEURLGHU\LVÀQLVKHG7RXFK2.WRNHHSWKHGHVLJQ
ORDGHGDQGVWD\LQ(PEURLGHU\6WLWFK2XW)RUH[DPSOH
if you wanted to stitch the same embroidery design again,
LQFOXGLQJDQ\FKDQJHV\RXKDYHPDGH
Raise needle
When the needle is lowered with the handwheel to check
the needle position on the fabric, a pop-up message is
displayed when trying to adjust the hoop position. Check
WKHER[WREHDEOHWRÀQHWXQHWKHKRRSSRVLWLRQZLWKWKH
needle lowered.
Note: Make sure the needle is above the fabric to prevent damage to
the needle and fabric.
Note: The warning cannot be disabled when the needle is below the
stitch plate.
Change to Cutwork Needle (optional accessory)
6RPHFXWZRUNGHVLJQVFDQEHVWLWFKHGRXWXVLQJWKH
RSWLRQDODF8649$51$9,.,1*
® Embroidery
&XWZRUN1HHGOH.LW317KHVHGHVLJQVDUH
PDUNHGZLWKDFXWZRUNQHHGOHV\PEROLQWKH'(6,*1(5
',$021'
Royale
™
6DPSOHU%RRN:KHQWKHPDFKLQH
stops and this pop-up message is shown, insert the
FRUUHVSRQGLQJFXWZRUNQHHGOH7RXFK2.DQGSUHVVWKH
6WDUW6WRSEXWWRQWRUHVXPH
Note: These cutwork designs can also be stitched out without
the cutwork needles, but that color block will then have to be cut
manually. If cutting manually, go to the next color block in the color
block list when the pop-up appears.
Machine needs to rest
If the machine stops and this pop-up appears on the
VFUHHQWKHPDFKLQHQHHGVWRUHVW:KHQWKH2.LFRQLV
enabled you can resume embroidering. The embroidery
results will not be affected.