Huntleigh Smartsigns Liteplus, Instructions For Use Manual, Page: 33 / 92

33
6.9 Resetting to Factory Defaults
Following procedure will allow you to reset the monitor operating parameters to the factory
default settings.
With the monitor powered off:
1. Simultaneously press the Power button and the NIBP start/stop button.
2. The monitor runs a self-test and then displays the current monitor software
version.
3. Press the Mode button until “ DEFAULT RESET=NO” is displayed.
4. To leave the settings unchanged, select ‘NO’ using only the Down (-)
selection button.
To reset the operating parameters to the factory default values, select ‘YES’
using only the Up (+) selection button. The monitor immediately resets to the
defaults and the con fi rmation tone sounds.
5. To return to normal operation, turn the monitor off; then restart.
SYS
DIA
MAP
%SpO
2
/min
°F
°C
M
mmHg
kPa
BP
1
SYS
DIA
MAP
%SpO
2
/min
Figure 15. Factory Defaults Setting
Using the Monitor