Huntleigh Smartsigns Liteplus, Instructions For Use Manual, Page: 26 / 92

26
SYS
DIA
MAP
%SpO
2
/min
°F
°C
M
mmHg
kPa
BP
1
SYS
DIA
MAP
%SpO
2
/min
°F
°C
M
mmHg
Figure 8. Normal Mode Before Measurement
Note: If the segment of ‘SYS’, ‘DIA’ and ‘MAP’ displays is blinking, do not use the
monitor and contact qualifi ed service personnel or Huntleigh Healthcare Ltd
Technical Services Department because this symptom indicates that an
internal problem may occur.
6.3 Setting Date and Time
This procedure will enable you to set current date and time of the monitor.
Note: The date format may be selected either ’year/month/day’ or ’day/ month/
year’ via Service mode.
With the monitor in the normal monitoring mode:
1. Press and hold the Mode button for 3 seconds until the monitor enters
Con fi guration mode.
2. Press the Mode button twice until the Time indicator and Hour set are fl ashing.
Set current time to increment Hour up and down between 0 and 23, using the
Up/Down (+/-) selection buttons.
3. Press the Mode button until the Time indicator and Minute set are fl ashing.
Set current minute between 00 and 59, using the Up/Down (+/-) selection
buttons.
4. Press the Mode button until the Time indicator and Second set are fl ashing.
Set current second between 00 and 59, using the Up/Down (+/-) selection
buttons.
5. Press the Mode button until the Date indicator and Year set are fl ashing.
Set current year, using the Up/Down (+/-) selection buttons.
Using the Monitor