Hunter Douglas Provenance Woven Wood Shades with PowerView Motorization, Installation Operation And Care

Page: 9 / 28

INSTALLATION
7
■
Attach the installation/extension brackets using the screws provided.
CautIon:
The rear of the installation/extension brackets
must be flush against a flat mounting surface. Do not mount
installation brackets on curved molding.
■
When using extension brackets, attach the installation
brackets using the screws and speed nuts provided.
Important:
For shades with attached battery wand, leave
at least
5
/
8
" between the wall side of the extension bracket
and the back of the installation bracket.
Important:
If your shade was ordered with a Crestover
™
Valance, see “If Your Ordered the Crestover™ Valance...” on page 8.
STEP 2 — Install the Shade
If You Have a Battery Wand Clip...
■
Attach the battery wand clip to the headrail.
Important:
Position the clip so that
the battery wand will be between
installation brackets.
■
Hook the battery wand clip onto the back
channel of the headrail.
■
Rotate the clip down until it snaps
into place.
CautIon:
Be sure the power cable does not become pinched by the brackets or headrail
during installation; damage or overheating of components could result.
CautIon: Do not connect the battery wand to the power cable prior to installing
the shade.
Mount the Headrail
■
With the headrail slightly tilted,
insert the front lip of the headrail
onto the front lip of the installation
bracket.
■
Push the headrail back and up until
its bottom lip snaps into bottom tab
on the installation bracket.
5
/
8
"
Minimum Required
for Attached
Battery Wand
Battery Wand Clip
Battery
Wand Clip
Headrail
Insert Front
Lip of Headrail
onto Bracket
Bottom
Tab
Push Up
and Back