OPERATION
14
Testing the Shade
Testing the shade with the manual control button will allow you to ensure that the motor and
power source are working correctly.
CautIon:
When raising the shade for the first time, observe how the fabric stacks. It should
stack evenly. Immediately stop the shade if the bottom rail is not level or the shade starts to rub
against either window jamb. See “Troubleshooting” on page 17.
■
Press and release the manual control button on the bottom
of the end cap behind the fabric to test operation.
If the shade does not operate, see “Troubleshooting” on page
17.
➤
Press and release the button to alternately lower, stop,
and raise the shade.
note:
With Top-Down/Bottom-Up shades, the manual
control button will alternately lower the bottom rail,
lower the middle rail, raise the middle rail, and raise
the bottom rail.
Using the PowerView
™
Remote
First, activate the remote by pulling both plastic tabs from the back battery compartment.
Important:
If you have more than one remote, see “Adding Additional Remote(s) to the
PowerView
™
Shade Network” in the
PowerView Motorization Remote Control Guide.
Push
Up
Side View of
the Shade
Manual
Control
Button
Fabric
Return
Group 1
Group 2
OPEN
CLOSE
Group 3
Group 4
Group 5
Group 6
Favorite
(Shading position)
LEFT ARROW
Lowers the middle rail on
Top-Down/Bottom-Up
RIGHT ARROW
Raises the middle rail on
Top-Down/Bottom-Up
STOP
(Press and hold for
programming mode)
Summary of Contents for Provenance Woven Wood Shades with PowerView Motorization
Page 1: ...Provenance Woven Wood Shades PowerView Motorization Installation Operation Care ...
Page 25: ...Notes ...
Page 26: ...Notes ...
Page 27: ......
