Range of values
Typical values
Parameter
Not applicable
Disabled
H.323 Proxy
Not applicable
Disabled
Dialer Proxy
Not applicable
Enabled
TCP Acceleration
Not applicable
Enabled
HTTP GET Compression
Not applicable
Enabled
DNS Caching
Not applicable
Enabled
Turbo Page
Not applicable
Disabled
SSL Acceleration
State codes
A state code is a number that indicates the operational state of the satellite modem. Some state codes indicate an error
condition. State codes are identified as
State code
followed by a number from 1 – 35. They are displayed with an
explanation in words, as shown in the following example.
State codes appear on screens displayed during a hard reboot (when power is removed and then restored) and on System
Control Center pages.
Figure 20: Examples of state codes
Table 12: State codes
on page 29 lists and explains all HN9000 state codes.
In the state code table,
modem
refers to the
satellite modem
.
Table 12: State codes
Corrective action
Explanation
State name
State code
Installation – Boot phase
Transient – No action is necessary.
Satellite modem is starting up in boot
phase.
Starting Up in Boot
1
Transient – No action is necessary.
Modem has not been installed, and
installation parameters have not been
submitted.
Waiting for Installation
Parameters
2
Transient – No action is necessary.
Antenna pointing is in progress
(coarse or fine pointing).
Occurs
during modem installation only.
Coarse Pointing in
Progress
3
Transient – No action is necessary.
Occurs during Auto modem
replacement only:
Modem is searching
for beacon.
Acquiring Beacon in Boot
4
29
Chapter 2
HN9000 Satellite Modem User Guide –
1037577-0001 Rev. B
System Control Center
