Interfaces and software update
Chapter 6
OPERATION MANUAL
V2.4.0en/08.12.20//17.12
CC®-Immersion circulator
61
Communication with the Pilot ONE is via TCP (Transmission Control Protocol),
Port 8101. The interfaces used must meet the specifications of the generally accepted standards.
6.1.2
USB-2.0 interface
The interfaces used must meet the specifications of the generally accepted standards.
6.1.2.1
USB-2.0 interface, host
USB-2.0 connection (for connector A), e.g. for data memories.
6.1.2.2
USB-2.0 interface, device
USB-2.0 connection (for Mini-B connector) for communicating with a computer.
6.2
Interfaces on the temperature control unit
6.2.1
Interfaces at the back
6.2.1.1
Service interface
This interface is exclusively used by Huber service engineers for service purposes. An adapter cable
makes this interface a RS232 serial port.
6.2.1.2
Female RS232 serial
A PC, a SPS or a Process Control System (PCS) can be connected to this jack for remote control of the
controller electronics. Before plugging in the cable, check the settings in the “Interfaces” category
and adjust if necessary.
The interfaces used must meet the specifications of the generally accepted standards.
Pin
Signal
Description
2
RxD
Receive Data
3
TxD
Transmit Data
5
GND
Signal GND
Interfaces at the back
of the immersion
circulator (exemplary
layout)
Pin assignment (front
view)
Pin assignment
