Command Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches
Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-41
For the related commands, see
ospf dr-priority
.
Example
# Set the interface Vlan-interface 1 to NBMA type.
[Quidway] interface Vlan-interface 1
[Quidway-Vlan-interface1] ospf network-type nbma
3.1.39 ospf timer dead
Syntax
ospf timer dead
seconds
undo ospf timer dead
View
Interface view
Parameter
seconds:
Dead interval of the OSPF neighbor. It is in second and ranges from 1 to
65535.
Description
Using
ospf timer dead
command, you can configure the dead interval of the OSPF
peer. Using
undo ospf timer dead
command, you can restore the default value of the
dead interval of the peer.
By default, the dead interval for the OSPF peers of
p2p
and
broadcast
interfaces are
40 seconds, and for those of
p2mp
and
nbma
interfaces is 120 seconds.
The dead of OSPF peers means that within this interval, if no Hello message is
received from the peer, the peer will be considered to be invalid. The value of
dead
seconds
should be at least 4 times of that of the
Hello
seconds
. The
dead
seconds
for
the routers on the same network segment must be identical.
For the related commands, see
ospf timer hello
.
Example
# Set the peer dead on the interface Vlan-interface 1 to 80 seconds.
[Quidway] interface Vlan-interface 1
[Quidway-Vlan-interface1] ospf timer dead 80
