Connects with the maintenance terminal over the Ethernet. The IP address of the
maintenance terminal must be set as 192.168.3.11 in order to connect with the configuration
network port.
l
System debugging serial port
Communicates with the maintenance terminal through a serial cable (RJ45 to DB9).
l
Management port
Connects with the maintenance terminal over the Ethernet.
Both the configuration network port and the system debugging serial port are on the front of the
VIS6000, as shown in
.
Figure 2-1
Locations of the configuration network port and the system debugging serial port
1
2
1 Configuration network port
2 System debugging serial port
The VIS6000 has two 100 Mbit/s management network ports, which are respectively used for
controller A and controller B. The management network ports are on the rear of the VIS6000.
Using the VIS6000 with two FC interface modules and four GE interface modules,
shows the locations of the management network ports.
Figure 2-2
Locations of the management network ports (take the VIS6000 configured with AC
as an example)
4
3
2
1
1 Active indicator of the management network port
2 Management network port of controller A
3 Link indicator of the management network port
4 Management network port of controller B
The differences and relations between the management network port, the configuration network
port, and the system debugging serial port are described as follows:
OceanStor VIS6000 Series Virtual Intelligent Storage
System
Initial Configuration Guide
2 Check Before the Configuration
Issue 08 (2010-05-10)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2-9
