WenZhou ZhengBang Electronic Equipment Co., Ltd
ZB4050LS Rev 1.1
24
！
Attention
：
The PCB design is not made by Mark, and the points or components on the PCB can be arbitrarily
positioned as identification points.
It is recommended that Mark1 be positioned in the lower left corner of the PCB. Mark2 is positioned in the
upper right corner of the PCB.
4-3-2 Mark Recognition Methods
Fig.4-30 Recognition Methods
1.
Manual Identification Method
：
After the production starts, when the PCB position is offset, you need to manually adjust the
coordinates to align the MARK1 and MARK2 centers for calibration.
2.
Automatic Identification Method
：
After production is started, the system finds and calibrate MARK based on the set MARK image
automatically.
3.One by one Identification: Multi-board is calibrated one by one.
！
Attention
：
Mark Automatic Identification Offset caused by PCB placement offset, PCB edge cutting irregularity.
Therefore, the recognition range should not be too large, otherwise the system will not be able to recognize.
The recommended range does not exceed 1.5 times the outer diameter of Mark, and don’t appear the similar
points in the identification area.
4-4 Feeder Edit
Type
Ribbon Feeder
Vibration Feeder(Tube)
IC Tray
Feeder No.
FD001-FD064
TP065-TP100
TP065-TP100
Coordinate
First Component Center First Component Center The first center in the lower left corner of the tray
Quantity
Actual Amount
Total (1)
Total Number (Y direction line)
Offset
0
0
Offset1
：
Position the center of the first component
in the lower right corner of the tray
Offset2
：
Position the center of the first component
in the upper right corner of the tray
Other Parameters
Consistent Editing
4-4-1 Ribbon Feeder Edit
1.
Open Feeder
：
Select “Edit—Feeder” to enter the feeder editing interface, click the feeder number in the feeder list, and click “Start”
to open.
