28
WFS 101545 Operations Manual
a.
Filter Element Installation
The filter elements or cartridges are provided by the customer. The specific filtration /
particulate size and element medium is determined by individual customer requirements.
i.
Remove the cover. The six wing nuts should be loosened in a
“Star” pattern in the sequence shown. See Figure 5-13
ii.
Remove the three Cartridge nuts
iii.
If there are existing filter cartridges installed remove them.
iv.
Install new filter elements. Make certain that the bottom of the
cartridge is over the centering cross. If the cartridge has a rubber
element on each end make certain that it remains in position as
you lower the element over the tie rod. See Figure 5-14
v.
Tighten the Cartridge Nuts down on the filter elements. Be sure to center the element
as the nuts are tightened down. Visually check to make sure the bottom of the filter
element is centered over the sealing ring.
FIGURE 5-13
FIGURE 5-14
FIGURE 5-15
