HST HP101U, Installation And Operation Manual

Page: 28 / 36

CHAPTER 3:
Programming Instructions
This chapter describes programming the PANEL from the onboard keypad. Programming can be performed only
by a factory authorized representative. Control panel programming is possible at any time except when an alarm
or zone fault condition is present or during a fire test.
All programming selections are stored in nonvolatile Electrically-Erasable Programmable Read-Only Memory
(EEPROM). This ensures that the control panel will remember all entries made in programming mode even if both
AC and battery power are removed.
The control panel comes with factory chosen options already programmed. Other options may be programmed if
desired. If all factory default settings are acceptable, programming is complete.
Successful entry into Program Mode from the keypad shuts off the fire protection and causes the all other LED
turn off except the relative function programming LED.
3.1 Key Functions
The function of each key in Program Mode is illustrated below:
3.2 Entering Program Mode
To enter program mode, the Mode key must be pressed and held for more than three seconds (time to prevent
accidental activation).
Once in Programming Mode, the control panel will:
✓ The piezo sounder beep twice
✓ Blink the Activate LED upon first entering Program Mode
✓ Turn off all other LEDs
3.3 Programming Functions
There are four features can be programmed as below:

Manual Activate Sound 1-4 Output directly

Disable Zone1-16

Disable Sound 1-4

Switch panel running mode in manual and automatic.
3.4 Activate Sound Output by manual
1. Press and held Mode key for more than three seconds until the Activate LED blinks.
2. Press “Enter (Mode)” key to activate ALL Sound output. The corresponding relay is activated.
Page 28 of 36