HST HP101U, Installation And Operation Manual

Page: 14 / 36

1.2 Specifications
AC Power
90-270 VAC, 50 Hz, 2.3 amps
Wire size: minimum #14 AWG (2.0 mm
2 ) with 600V insulation
Battery (lead acid only)
Maximum Charging Circuit: Normal Flat Charge—27.6V @ 0.8 amp
Maximum Charger Capacity: 18 Amp Hour batter
Sound Output Device Circuits
General Alarm Zones 1 through 16
Operation: All zones Class B
Normal Operating Voltage: Nominal 24 VDC (ripple = 100 mV maximum)
Alarm Current: 15 mA threshold
Short Circuit Current: 42 mA maximum
Maximum Loop Resistance: 100 ohms
End-of-Line Resistor: 4.7K, ½ watt
Detector Loop Current is sufficient to ensure operation of two alarmed detectors per zone
Standby Current: 7.26 mA
Three Relays Output
Relay contact rating: 2.0 amps @ 30 VDC (resistive), 2.0 amps @ 30 VAC (resistive)
Nonresettable 24 VDC Power
Maximum ripple voltage: 10 mVRMS Operating Voltage nominal 24 volts
Total DC current available from this output is up to 500 mA
Recommended maximum Standby current is 150 mA
1.3 Controls and Indicators
Front Panel Keys in Normal Mode

Silence

Mute

Test/


Reset/


Mode
LEDs

AC Power - green or yellow LED

Battery - green or yellow LED

Mute - yellow LED

Silence - yellow LED

Fire Alarm - red LED

Fault - yellow LED

Supervisory - red LED

Activate - red LED

Zone Disabled - yellow LED

Sound Disabled - yellow LED
Page 14 of 36