94
Operator's Manual
B 235 Evo
values displayed : 000 000;
- grams displayed in units of 5 (or 1/4 of an ounce);
- active sensor rounding-off (version with digital sensor)
- default geometric values: width = 5.5”, diameter = 14”, distance = 150 mm.
Now the operator can set the data of the wheel to be balanced or select one of the pro-
grammes available.
1.1 USING THE AUTOMATIC WHEEL
CLAMPING SYSTEM C
Procedure for locking the wheels with the automatic C system:
Centring with front cone
- Fit the wheel on the shaft, sliding it into place until it rests against the flange.
- Fit the most suitable cone on the shaft and insert it into the central hole of the wheel.
- Fit the locking device by making it slide on the hub until it comes into contact with the
cone.
- Press the control pedal for at least one second.
Centring with rear cone
- Fit the most suitable cone for the central hole of the wheel on the shaft.
- Fit the wheel onto the cone, sliding it into place until the cone comes into contact with
the plate that holds the spring.
- Apply the protective cap to the sleeve.
- Fit the locking device by making it slide on the hub until it comes into contact with the
wheel.
- Press the control pedal for at least one second.
Wheel release
- Press the control pedal for at least one second to release the wheel from the flange.
Centring with flanges
Removing the C hub
- press button A (figure 11) to discharge any air that may be in the clamping system;
11
