HP StoreEasy 3000, Administrator'S Manual

Page: 82 / 102

Table 5 Known issues (continued)
Resolution Issue
Please ensure that all GPT
disks have a Microsoft
a.
Get-partition –DiskNumber <disk number from above> |
remove-Partition –Confirm
Reserved Partition (MSR)
present. Error: 0x80070022
b.
New-partition –DiskNumber <disk number from above>
-Size 128MB –GptType
‘{e3c9e316-0b5c-4db8-817d-f92df00215ae}'
c.
New-partition –DiskNumber <disk number from above>
-Size <size> –AssignDriveLetter | Format-Volume –Force
3. Enter the
Get-partition –DiskNumber <disk number from above>
command to verify the new partitions.
To create the missing partition using diskpart, perform the following steps:
1. Open an elevated PowerShell command shell.
2. Enter
diskpart.exe
, and then execute the following commands:
a.
rescan
b.
list disk
NOTE: Note the disk number that corresponds to the disk that you want
to add to the cluster.
c.
select disk
d.
clean
e.
create partition msr size=128
f.
create partition primary size=<size in MB>
NOTE: This size parameter is optional. If you do not enter a value, the
complete remaining space is used.
g.
format fs=ntfs quick label=”<disk label>”
h.
exit
3. Enter the
Get-partition –DiskNumber <disk number from above>
command to verify the new partitions.
Method 2—Non-destructive partition creation
IMPORTANT: To use this method, you must have at least 128 MB of unpartitioned
space on the disk.
To create the missing partition using PowerShell, perform the following steps:
1. Open an elevated PowerShell command shell.
2. Enter the following command to create MSR and data partition using the disk
number found in the output of the
Get-disk | where
{$_.PartitionStyle –eq “GPT”}| get-partition
command:
New-partition –DiskNumber <disk number from above>
-Size 128MB –GptType
‘{e3c9e316-0b5c-4db8-817d-f92df00215ae}'
3. Execute the
Get-partition –DiskNumber <disk number from
above>
command to verify the new partitions.
To create the missing partition using diskpart, perform the following steps:
1. Open an elevated PowerShell command shell.
2. Enter
diskpart.exe
, and then execute the following commands:
a.
rescan
b.
list disk
NOTE: Note the disk number that corresponds to the disk that you want
to add to the cluster.
c.
select disk <disk number>
82 Troubleshooting, servicing, and maintenance