35
Core Switch 2/64 and SAN Director 2/128 installation guide
Installing the switch in specified racks
Use the following procedure to install the Core Switch 2/64 or the SAN Director 2/128 in an
HP 10,000 series or HP System/e rack using the 14U Rack Mount Kit supplied with the switch.
Allow approximately 45 minutes to complete this procedure.
NOTE:
These instructions describe how to install the switch in the bottom area of the rack
(section closest to the floor). You may need to orient 14U Rack Mount Kit hardware based on
your particular rack’s configuration.
Attaching the rack mount shelf brackets
Use these steps to install the rack mount shelf brackets.
CAUTION:
You can install up to two Core Switch 2/64 or SAN Director 2/128 switches. HP
supports up to two switches in the racks specified for each switch.
1.
If you have not already done so, remove the chassis door. See ”
Removing the chassis door
”
on page 30.
2.
Locate the left and right rack mount shelf brackets. Refer to
Figure 3
and
Table 4
to identify
the hardware.
3.
Loosen the adjusting screws on the left and right rack mount shelf brackets, and adjust the
length of the brackets according to the depth of the rack. See
Figure 5
.
4.
Locate the small, round marker holes on the rack rails. Each marker hole delineates the
beginning of one rail unit, or U. Leave 1U of space free at the bottom of the rack.
5.
Count up five square holes from the 1U location. Align the left rack mount shelf brackets
with the fifth square hole.
6.
Attach the rack mount shelf brackets:
a.
For rails with round holes, position the left and right rack mount shelf brackets with
notched portion toward exhaust aisle (see
Figure 5
) and attach to rack rails, using six
1/4-20 x 0.500-inch (1.27 cm) screws with lock washers per bracket (two on the
notched end and four on the other end).
b.
For rails with square holes, attach the left rack mount shelf bracket to the rack rails using
six 1/4-20 x 0.500-inch screws and six square washers. See
Figure 5
.
CAUTION:
All 14U Rack Mount Kit hardware and screws are supplied with the switch. Use
the exact screws specified in the procedure. Using longer screws may damage the chassis.
Summary of Contents for StorageWorks 2/64 - Core Switch
