Hardware options installation 33
Hardware options installation
Introduction
If more than one option is being installed, read the installation instructions for all the hardware options and
identify similar steps to streamline the installation process.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION:
To prevent damage to electrical components, properly ground the server before
beginning any installation procedure. Improper grounding can cause electrostatic discharge.
Drive cage options
4-bay LFF hot-plug drive cage option
To install the component:
1.
Power down the server (on page
18
).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Place the server on its side.
4.
Remove the access panel (on page
18
).
5.
Remove the front bezel (on page
20
).
6.
If installed, remove the PCI air baffle (on page
22
).
7.
Remove the system air baffle (on page
23
).
8.
Disconnect all existing drive cage cables.
Summary of Contents for ProLiant ML110 Gen9
