Hardware options installation 103
8.
Install the dedicated iLO management module.
9.
If removed, install the expansion board.
10.
Install the access panel (on page
26
).
11.
Do one of the following:
o
Slide the server into the rack.
o
Install the server into the rack ("
Installing the server into the rack
" on page
36
).
12.
Power up the server (on page
20
).
13.
Enable the dedicated iLO connector ("
Enabling the dedicated iLO management module
" on page
103
).
Enabling the dedicated iLO management module
The onboard NIC 1/shared iLO connector is set as the default system iLO connector. To enable the
dedicated iLO management module, use the iLO 4 Configuration Utility accessible within the HP UEFI System
Utilities.
For more information on the HP UEFI System Utilities, see the UEFI documentation on the HP website
(
http://www.hp.com/go/ProLiantUEFI/docs
).
IMPORTANT:
If the iLO configuration settings are reset to the default values, remote access to the
machine will be lost. Access the physical machine and repeat the procedure described in this
section to re-enable the dedicated iLO management connector.
To enable the dedicated iLO management module:
1.
During the server startup sequence after installing the module, press
F9
in the POST screen.
The System Utilities screen appears.
2.
Select
System Configuration
|
iLO 4 Configuration Utility
.
The iLO 4 Configuration Utility screen appears.
3.
Select
Network Options
, and then press
Enter
.
The Network Options screen appears.
