Removal and Replacement Procedures
2-28
HP ProLiant DL145 Generation 2 Server Maintenance and Service Guide
•
Handle the processor and heat sink with care. Damage to either may affect processor
performance.
•
The pins beneath the processor are very fragile. Do not bend or damage them.
•
Always use a new heat sink when replacing processors. Failure to use new components
can cause damage to the processor.
•
Be sure that the server has the most recent ROM version. Failure to flash the ROM before
installing processors can cause system failure.
•
To prevent the heat sink from tilting to one side during installation/removal procedures,
observe a diagonally opposite pattern (an “X” pattern) when loosening and tightening the
four spring-loaded screws.
To remove a processor:
1.
Perform the pre-installation procedures described on page 2-5.
2.
If necessary, remove any accessory boards or cables that prevent access to the air duct.
3.
Lift the air duct away from the processor sockets.
Keep it for reinstallation later.
Figure 2-33: Removing the air duct
4.
Locate the processor you want to remove.
All manuals and user guides at all-guides.com
