Removal and Replacement Procedures
HP ProLiant DL145 Generation 2 Server Maintenance and Service Guide
2-7
Opening the Server
The top cover is detachable. You need to remove this cover before you can remove or replace
a server component.
To remove the top cover:
1.
Perform steps 1 and 2 of the pre-installation procedures described on page 2-5.
2.
Detach the top cover from the chassis:
a.
Loosen the captive thumbscrew on the rear panel.
b.
Slide the cover approximately 1.25 cm (0.5 in) toward the rear of the unit, then lift
the cover to detach it from the chassis.
Figure 2-1: Removing the top cover
3.
Place the top cover in a safe place for reinstallation later.
To reinstall the top cover:
1.
Perform steps 1 through 4 of the post-installation procedures described on the previous
page.
2.
Reinstall the top cover:
a.
Align the cover to the chassis and then slide it towards the front panel to position it
into place.
b.
Once the cover is attached to the chassis, secure it by tightening the captive
thumbscrew on the rear panel.
All manuals and user guides at all-guides.com
