Removal and Replacement Procedures
Hard Drive Assembly
IMPORTANT:
Hard drives and processors for the ProLiant BL e-Class server blade are model specific.
For more information, refer to the QuickSpecs on the HP website.
To remove the hard drive assembly from a ProLiant BL e-Class server blade:
1. Power down the server blade. See the “Powering Down a Server Blade” section in this
chapter.
2. Remove the server blade from the enclosure. See the “Removing a Server Blade” section
in this chapter.
3. Place on a level, nonconductive surface.
4. Using a Torx T-15 tool, remove the screws holding the hard drive assembly to the server
blade (1).
5. Slide the hard drive assembly toward the processor, and lift it from the server blade (2).
Figure 2-23: Removing the hard drive assembly from a server blade
NOTE:
Figure 2-23 shows the ProLiant BL10e server blade.
Reverse steps 1 through 5 to replace a hard drive assembly.
Server Blade Battery
To remove a server blade battery:
1. Power down the server blade. See the “Powering Down a Server Blade” section in this
chapter.
2. Remove the server blade from the enclosure. See the “Removing a Server Blade from the
Enclosure” section in this chapter.
HP ProLiant BL e-Class System Maintenance and Service Guide
2-27
HP CONFIDENTIAL
Codename: Kerr Part Number: 249066-004 Last Saved On: 5/12/03 3:00 PM
