Removal and Replacement Procedures
Removing the Interconnect Tray
To remove the interconnect tray:
1. Power down each server blade. See the “Powering Down a Server Blade” section in this
chapter.
2. Power down the enclosure. See the “Powering Down the Enclosure” section in this
chapter.
3. Disconnect all cables and power cords from the AC power source.
4. Disconnect all cables and power cords from the enclosure rear panel.
IMPORTANT:
Perform steps 5 and 6 simultaneously in both power-supply bays.
5. Remove both hot-plug power supplies. See the “Hot-Plug Power Supplies” section in this
chapter.
6. Release the locking latches securing the interconnect tray in the enclosure (1).
7. Pull the release latches toward the rear of the enclosure (2).
8. Remove the interconnect tray from the enclosure (3).
Figure 2-10: Removing the interconnect tray from the enclosure
Reverse steps 1 through 8 to replace the interconnect tray.
IMPORTANT:
When installing the interconnect tray, be sure that the release latches are in the open
position. When closing the release latches on the interconnect tray, be sure that the locking latches
click audibly into place.
2-14
HP ProLiant BL e-Class System Maintenance and Service Guide
HP CONFIDENTIAL
Codename: Kerr Part Number: 249066-004 Last Saved On: 5/12/03 3:00 PM
