SROS Command Line Interface Reference Guide
BVI Interface Config Command Set
5991-2114
© Copyright 2007 Hewlett-Packard Development Company, L.P.
800
ip ospf
Use the
ip ospf
command to customize OSPF settings (if needed). Use the
no
form of these commands to
return to the default settings. Variations of this command include:
ip ospf authentication-key
<password>
ip ospf cost
<value>
ip ospf dead-interval
<seconds>
ip ospf hello-interval
<seconds>
ip ospf message-digest-key
[1 | 2]
md5
<key>
ip ospf priority
<value>
ip ospf retransmit-interval
<seconds>
ip ospf transmit-delay
<seconds>
Syntax Description
authentication-key
Specifies a simple-text authentication password to be used
by other routers using
<password>
the OSPF simple
password authentication.
cost
<value>
Specifies the OSPF cost of sending a packet on the interface.
This value overrides any computed cost value.
Range: 1 to 65,535.
dead-interval
<seconds>
Sets the maximum interval allowed between hello packets. If
the maximum is exceeded, neighboring devices will
determine that the device is down. Range: 0 to 32767.
hello-interval
<seconds>
Specifies the interval between hello packets sent on the
interface. Range: 0 to 32,767.
message-digest-key
<keyid>
md5
<key>
Configures OSPF Message Digest 5 (MD5) authentication
(16-byte max) keys. The SROS allows two keys (key ID
1
and
key ID
2)
.
priority
<value>
Set the OSPF priority. The value set in this field helps
determine the designated router for this network.
Range: 0 to 255.
retransmit-interval
<seconds>
Specifies the time between link-state advertisements (LSAs).
Range: 0 to 32,767.
transmit-delay
<seconds>
Sets the estimated time required to send an LSA on the
interface. Range: 0 to 32,767.
Default Values
retransmit-interval
<seconds>
5 seconds
transmit-delay
<seconds>
1 second
hello-interval
<seconds>
10 seconds: Ethernet, point-to-point, Frame Relay, and PPP
dead-interval
<seconds>
40 seconds
