HP ProCurve Secure 7102dl, Reference Manual

Page: 1349 / 1455

SROS Command Line Interface Reference Guide Network Monitor Track Configuration Command Set
5991-2114 © Copyright 2006 Hewlett-Packard Development Company, L.P. 1347
N
ETWORK
M
ONITOR
T
RACK
C
ONFIGURATION
C
OMMAND
S
ET
This section explains the commands available for Network Monitoring Tracks. Tracks are objects created
to monitor network probes for a change in their state. The tracks can be configured to perform a specific
action based upon the probe state detected. Association between a track and a probe occurs through
referencing the probe in the track’s configuration. Once the track is registered with the probe, whenever a
change occurs with the probe’s state, an event is sent to the track.
Additional configuration commands are available for creating probes. These are explained in the Network
Monitor Probe Command Set on page 1330.
To activate the Network Monitor Track Configuration mode, enter the track command at the Global
Configuration mode prompt followed by the name of the track. For example:
> enable
# configure terminal
(config)# track track1
(config-track-track1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
exit on page 1437
All other commands for this command set are described in this section in alphabetical order:
dampening-interval
<value>
on page 1348
log-changes on page 1349
shutdown on page 1350
test if on page 1351
test list on page 1354
test list weighted on page 1357