enable wdt
The command
enable wdt
enables the operating system watchdog timer (disabled by
default). This timer is available only with Tru64 UNIX. For more information see the
section in Chapter 3 on Setting Up the Watchdog Timer.
env
The
env
command provides a current snapshot of the status of the system environment
(voltages, temperature, fans). If a sensor has crossed its warning threshold, it is displayed
bold; if a sensor has crossed its fatal threshold, the reading is displayed bold and blinking.
fwrev
The
fwrev
command displays the RMC-accessible firmware revisions. Note that prior to the
first successful SRM-console load, the RMC only has access to the RMC Booter image and
RMC Runtime image firmware revisions.
halt
The
halt
command halts the system. This is the same as pressing and releasing the
momentary contact halt button on the OCP. (Jumper J22 pins 13-14 must not be installed for
the halt/reset button to operate as a halt button.)
halt in
The
halt in
command
asserts halt to the system, halting the platform. To deassert a halt,
issue the
halt out
command.
NOTE:
Halt will de-assert if system power is cycled.
halt out
The
halt out
command releases the system from the halted state.
hangup
The
hangup
command terminates the current modem session. A modem session
automatically terminates after a period of idle time set by the
set logout
command (default =
20 minutes).
help or ?
The
help
or
?
command displays the RMC command set.
6-40
hp AlphaServer TS15 Owner’s Guide