HP 53131A, Operating Manual

Page: 131 / 196

Chapter 2 Operating Your Universal Counter
Using the Save and Recall Menus
Operating Guide 2-55
2
To Unsave a Measurement Setup
1 To unsave the measurement setup you’ve saved in the previous procedure,
press Save & Print key until
UNSAVE: NO is displayed.
2 Press the appropriate arrow keys to select UNSAVE: 1 , then press Enter
key.
The measurement setup that was saved in register 1 ( RECALL: 1 )
is deleted or unsaved.
ADDITIONAL INFORMATION ABOUT UNSAVE
If the UNSAVE: display DOES NOT show up after the SAVE: display, then
no setups have been saved; all registers are empty.
If UNSAVE: display is present in the Save & Print key menu, then at
least one setup has been saved. (To determine how many setups are saved,
continuously press the
d
key while UNSAVE: n is displayed and count
the number of registers that are present.) Perform step 2, below, to delete
a measurement setup.
1 Suppose there are two registers (1 and 2) that have setups saved in them.
To remove these setups, perform the following:
a. At the UNSAVE: 1 display, press Enter key.
UNSAVE: 2 is displayed, indicating that register 1 has been cleared.
To check if the clearing was done, press the
d
key; the “
1
” display
should not exist.
b. At the UNSAVE: 2 display, press Enter key.
All registers are cleared when the UNSAVE menu item is NOT present
in the Save & Print key menu.
2 Now, suppose in the previous step (2) you wanted to leave register 1 alone,
but you want to delete register 2. Perform the following steps:
a. At the UNSAVE: 1 display, press
d
key.
UNSAVE: 2 is displayed.
b. Press Enter key to delete register 2.