Figure 12 Disk drive numbering
CAUTION:
Install hard drives in the enclosures only after securing the enclosures in the rack:
•
An enclosure populated with hard drives is too heavy to lift safely.
•
Movement of an enclosure during installation might damage the internal storage media of
installed hard drives.
CAUTION:
Follow industry-standard practices when handling hard drives. Internal storage media
can be damaged when drives are shaken, dropped, or roughly placed on a work surface. When
installing a hard drive, make sure it is fully seated in the drive bay. To remove a hard drive, press
the release button and pull the drive only slightly out of the enclosure. Then, to allow time for the
internal disk to stop rotating, wait approximately 10 seconds before completely removing the drive
from the enclosure.
To install the hard drives:
1.
Insert the disk drive into the drive bay (1,
Figure 13 (page 17)
) until it clicks, locking the drive.
2.
Rotate the drive lever to the right (2,
Figure 13 (page 17)
) until it locks.
Figure 13 Installing drives into the enclosures
Installing SFPs
The HSV300-S controller uses Small Form Factor Pluggable (SFPs) transceiver modules on the FC
ports. Four SFPs are factory installed in the HSV300-S, but you will need to install additional SFPs
if you plan to use more than four switch ports. If you purchased extra SFPs, install them now,
following the instructions shipped with the SFPs.
NOTE:
The HSV300-S requires 4 Gb or higher SFPs.
Installing SFPs
17
