49 of 61
Indesit
Company
Service Manual UK
English
ZE. WATER TUBES/HOSES - QUICK COUPLING (where possible observe best hygiene
practises when handling drinking water tubes/components to avoid contamination)
The water tubes/hoses/pipes within this appliance are fitted with a quick coupling connection.
They have a Quick Connect valve which has Push-in-tube connections.
1.
Pencil mark (approx.12mm) the tube insertion length before removing (if not already marked).
This is to help you indicate the length when re-inserting the tube.
2.
Remove a water tube by depressing the rubber collar.
Note:
Always check for leaks after reassembling.
ZF. ICE MAKER WATER TUBE - 2011 NDF MODELS - Refer to Section ZE Water Tube Removal
1.
Unscrew the plinth (2 screws) and remove it. Then
disconnect the blue coloured tube from the
connector.
2.
Remove the dispenser grid and unscrew the both
screws from the dispenser housing and pull it to
the front to release it.
3.
Disconnect all connectors from the User Interface
module.
4.
Pull out the blue water tube (base to dispenser
unit).
5.
Remove the ice maker cover and plastic cover of
the ice maker water inlet tube.
6.
Pull out the black rubber and blue tube (including heater if fitted) from the support. Note: When
reassembling the plastic cover, it’s important to slide in the top guide to avoid air leakage in the top
(as shown in the Fig. 21).
Fig. 21
