47 of 61
Indesit
Company
Service Manual UK
English
8.
Withdraw the dispenser towards you to remove.
X.
DISPLAY PCB MODULE
1.
Remove the control panel interface as in W 1-4 above.
2.
Place dispenser box on its front on a work surface, remove the three screws to remove the display
board.
3.
When re-assembling ensure the wiring, once connected back, does not get trapped in the frame.
Tape up wires to left side of frame.
Y.
WATER FILTER HOUSING (Refer to section ZE on Page 49 for all water tube removal)
1. Remove front plinth/grille via two screws (it is not necessary to remove the plinth to get to just the
water filter itself).
2.
Remove the two screws from the filter housing (do not try to remove the housing from the front side
of the appliance in order to not damage the water tube).
3.
Disconnect the water tube connection located below the freezer door.
4.
At the rear of the appliance unscrew and remove the lower rear metal panel.
5.
Disconnect the water (8mm) and ice (6mm) tubes from the water (blue collar) and ice (yellow collar)
solenoid valve.
6.
Thread the third farthest water dispenser tube through the condenser fan housing (this connects to
the tube you have just disconnected at the front of the appliance).
7.
Unscrew the condenser fan housing and remove the complete assembly out of compressor bay.
8.
Remove the separator.
9.
Pull and manoeuvre the filter housing out from the compressor bay.
10. Remove the inlet and outlet tubes from the filter housing and fit to the replacement housing as
necessary.
Note:
Once all the components and water tubes are reassembled, check for water leaks on the
tube connections. If the housing inlet and / or outlet tube leaks, cut the tubes, using a sharp knife,
short and close to the filter housing at 90 degrees and reconnect it to the filter housing.
Z.
DISPENSER LEVERS
1.
Remove the control panel interface as in section W.
2.
Disconnect the various connectors.
3.
Push the back of the lever (whilst wearing protective gloves) through the small opening at the rear
of the control box. While pushing the lever also slide it upwards to release it from the 3 clips.
When replacing the levers ensure the original position of the 3 clips.
Fig. 17
Fig. 18
