Incline Motor Replacement
Tools required:
Philips screwdriver
Qty 2 wrenches (17mm)
Procedure:
1. Turn off the power to the treadmill and unplug the power cord from the wall outlet.
2. With a Philips head screwdriver, remove the motor cover. Disconnect the incline motor
wires from the lower control board.
3. Fold up the treadmill to the locking position.
4. With two 17mm wrenches, remove the bottom bolt attaching the motor shaft to the
incline frame. It may be helpful to tip the treadmill on its side to release pressure from
the shaft bolt.
5. Fold the treadmill down to the running position. Remove the top bolt from the
incline motor. Remove the incline motor from the machine.
6. When installing the new incline motor, make sure the elevation shaft is flush with the
motor casing (See diagram below).
7. Install the top bolt to the incline motor.
8. Install the bottom bolt to the incline shaft.
9. Reconnect the incline motor wires to the lower control board.
10. Attach the motor cover.
71
Summary of Contents for ELITE 1.1T
