Running Speed Is Not Stable (erratic speeds)
•
Verify that the running belt and drive belt tensions are adequate, preventing belts
from slipping.
•
Check voltage of wall outlet.
Warning! Hazardous voltages will be tested in the following procedure. Exercise
extreme caution when performing these procedures. Do not connect or disconnect
any wiring, connectors, or other components with the power applied to the treadmill.
•
Disconnect the treadmill power cord from the wall outlet. Using an AC voltmeter,
verify that the proper AC voltage is present at the wall outlet. Nominal 120 Vac
may vary between approximately 105 Vac and 135 Vac. If the AC voltage is
missing or incorrect, check the AC service or consult an electrician.
•
Make sure that the treadmill is connected to a dedicated 20amp circuit, with out the
use of an extension cord.
•
Verify that there are not any pinches or cuts in power cord, motor wires, or console
cable. Replace if necessary.
•
Adjust IR Comp dial on lower board.
•
Inadequate lubrication on deck and belt. Refer to treadmill Lubrication
procedures.
•
If problem persists, replace lower board.
42
Summary of Contents for ELITE 1.1T
