Running Belt/Deck Replacement Procedure
Tools required:
Philips screwdriver
T-handle Allen wrench (5mm, 6mm, 8mm)
Procedure:
1.
2.
3.
4.
5.
With a Philips head screwdriver, remove the motor cover, rear roller end caps, bottom
deck cover and left and right side rails.
With the appropriate size Allen wrench remove the rear roller. It is a good idea to note
the position of the rear roller before removing
.
For best results, place two removable
marks on the left and right side of the deck and the running belt. When reinstalling,
match up the marks for proper tension.
With the Philips screwdriver remove the speed sensor.
With a 6mm Allen wrench remove the front roller.
(It is a good idea to note the position of the rear roller before removing.)
Loosen the bolts that hold the deck to the frame and remove the running belt and deck.
Replace the deck and running belt with a new one.
58
Summary of Contents for ELITE 1.1T
