Tensioning or Aligning the Running Belt
Tensioning the Running Belt:
If you can feel a slipping sensation when running on the treadmill, the running belt must
be tightened. In most cases, the belt has stretched from use, causing the belt to slip.
This is a normal and common adjustment. To eliminate this slipping, tension both the
rear roller bolts with the appropriate sized Allen wrench, turning both the left and right
bolt
1/4 TURN
as shown below. Try the treadmill again to check for slipping. Repeat
if necessary, but
NEVER
TURN the roller bolts more than 1/4 turn at a time.
NOTE: The belt tension is set properly when the running belt is ¼ of an inch from
the deck, towards the rear roller.
10
Summary of Contents for ELITE 1.1T
