Tensioning the Drive Belt (1.1T, 2.1T, 3.1T)
Procedure:
1.
Turn off the power to the treadmill and remove the power cord from the wall
outlet.
2.
With a Philips head screwdriver, remove the motor cover.
3.
Unplug the motor wires from the lower board.
4.
Before continuing, it is a good idea to weight down the treadmill deck to prevent
the treadmill from springing up. Removing the weight of the motor will
significantly reduce the weight in the front end of the treadmill.
5.
With a 13mm wrench, loosen the attachment nuts (M08) and washers (M09)
holding the motor to the frame.
6.
With a 6mm Allen wrench, loosen the two motor bracket attachment bolts (M45,
M46) and adjust to proper position.
7.
Tighten the two motor attach bolts (M45, M46) with a 6mm Allen wrench.
8.
Verify the proper tension on the drive belt. Using a timing belt tension gauge, the
proper tension should be between 65 to 75 lbs. If a timing belt tension gauge is
not available, the drive belt should have approximately 3/8 of inch deflection. If
the drive belt tension is not set properly, loosen the motor attachment bolts and
adjust.
12
Summary of Contents for ELITE 1.1T
