Eng1– Hardware Test/Manual Calibration
Important Note:
Use to check running belt speed and manually calibrate machine.
1.1T
a) While in the Engineering Mode menu, press Speed
“+”
or
“- “
until Eng1 appears in the display.
b) Press
“Start”
to select Eng1 and
“Start”
again to get the belt started.
c) The readout in the speed window will indicate the start speed of the treadmill, which should be 0.5
mph (+ or - .05 mph). If the speed is not within the proper start speed range, adjust the Speed Cube
located on the board under the motor cover until the speed is approximately 0.5 mph (+ or – .05 mph) in
the Speed window.
*Refer to diagram.
Speed Cube
d) Once the speed cube is set to the proper setting. Press and hold the
“Stop”
for three seconds to
return to the Engineering Mode Menu.
Important Note:
Steps c) and d) are the same for the 1.1T through the 5.1T
2.1T, 3.1T
a) While in the Engineering Mode menu, press Speed “
∧
” or “
∨
“ until Eng1 appears in the display.
b) Press
“Start”
to select Eng1 and
“Start”
again to get the belt started.
c) Use steps c) and d) from 1.1T instructions
4.1T, 5.1T
a) While in the Engineering Mode menu, press Speed
“
∧
”
or
“
∨
“
until Eng1 appears in the display.
b) Press
“Select”
to select Eng1 and
“Start”
to get the belt started.
c) Use steps c) and d) from 1.1T instructions
The display window should reference the following values (3.1T, 4.1T, 5.1T models):
•
Calories/Elevation display window – software version
27
Summary of Contents for ELITE 1.1T
