S
YSTEM
I
NDICATORS
/
F
AULT
A
NALYSIS
/
T
ROUBLESHOOTING
System 6844(RC) - V03.00
145 / 157
hopf
Elektronik GmbH
Nottebohmstr. 41
• D-58511 Lüdenscheid • Tel.: +49 (0)2351 9386-86 • Fax: +49 (0)2351 9386-93 • Internet: http://www.hopf.com • E-Mail: [email protected]
9.2.9 No Daylight Saving Time (DST) Changeover
Description
"D" for “daylight saving time“ (summer time) does not appear on the display
The bit "daylight saving time" is not set in the status of the data string.
Cause / Problem Solution
Changeover points of time not set or set incorrectly
Output/display was configured for UTC and not for local time
9.2.10 Output and Function Errors of individual Function Boards
The respective board description should be consulted for error analysis of an individual
Function Board.
9.3
Support from the
hopf
Company
Should the System demonstrate error descriptions other than those listed in
Chapter 9.2 Er-
, please contact Support at
hopf
Elektronik GmbH with an exact description of
the fault and the following information:
With PCID (Product Config ID) or if not possible with the Serial number of the Sys-
tem
Occurrence of the error during commissioning or operation
Values of ERROR-Byte
Value of SYSTEM-Byte
Exact error description
Setting Sync.-Mode
In the case of GPS reception/synchronization problems
description of the antenna
equipment used:
o
Components used (antenna, indirect lightning protector, etc.)
o
Cable type used
o
Total length of the antenna equipment
o
Sequence of components and cable lengths between the components
o
Antenna installation position (e.g. signal shading by building) and
Please write to the following E-mail address with the above information:
Providing a detailed description of the error and the information listed above
avoids the need for additional clarification and leads to faster processing by
our Support team.
