Honeywell
COMPONENT MAINTENANCE MANUAL
PART NUMBER 964-0452
I.B.1516A Page INTRO-1
Mar 30/01
23-12-01
INTRODUCTION
This manual was prepared by Honeywell according to ATA Specification No. 100.
The front matter consists of a title page that displays the equipment name and part number, and the
ATA and document numbers assigned to the manual, a Record of Revisions page for recording
revision incorporation, a Record of Temporary Revisions page for recording temporary revision
(yellow page) insertion prior to formal revision, a Service Bulletin List that includes a brief
description of the reason for the bulletin, and the date that Service Bulletin information was
incorporated into the manual, a Table of Contents, and a List of Illustrations.
DESCRIPTION AND OPERATION
section contains an equipment illustration, table of leading
particulars, a general description, and a description of operation for electronic assemblies, to assist
in understanding the equipment for fault isolation purposes.
TESTING AND TROUBLESHOOTING
section contains tests to enable maintenance personnel to
assess the operational condition of the equipment, a troubleshooting guide to assist in fault
isolation, and schematics.
DISASSEMBLY
section contains procedures for disassembling the equipment to the part
replacement level. Complete overhaul procedures are not provided. Specific procedures are
intended to be a supplement to, and are correlated with the Illustrated Parts List (IPL).
CLEANING
section contains general cleaning procedures, which should be observed during repair
and part replacement where applicable.
CHECK
section contains general areas to visually observe during disassembly and assembly to
assure that equipment operational standards are met.
REPAIR
section contains specific instructions for repairing areas of the equipment not specifically
covered in the ASSEMBLY section.
ASSEMBLY
section contains all specific instructions necessary for part replacement and to
supplement the IPL.
FITS AND CLEARANCES
section contains a list of dimensional values, torques, etc., if required
during assembly. These parameters are also specified in the ASSEMBLY section where applicable.
SPECIAL TOOLS, FIXTURES, AND EQUIPMEN
T section contains a list of all special equipment
required to perform procedures specified in the other manual sections.
ILLUSTRATED PARTS LIST (IPL)
section contains illustrations and parts lists for all equipment
assemblies, subassemblies, and components. The illustrations and parts lists are item-number
keyed for location of parts, and list quantities, part numbers, and part descriptions. An introduction
to the IPL relates how it is used, definitions used, equipment designators, and alphanumerical
indices for parts.