Honeywell VISTA-128BPT, Installation And Setup Manual, Page: 24 / 124

VISTA-128BPT/VISTA-250BPT Installation and Setup Guide
3-8
TERMINALS
ON CONTROL
EARTH GROUND
INCOMING TELCO LINE
Handset
TIP RING
RJ31X
JACK
PLUG
DIRECT
CONNECT
CORD TIP
RING
GROUND
PREMISES
PHONES
{ {
BROWN (TIP) GREY (RING)
GREEN (TIP) RED (RING)
26 27 28 29 30
Incoming
Telco Line
Figure 3-8: Telephone Line Connections
Wiring Burglary, Panic and Smoke Detector Devices to Zones 1-9
The maximum zone resistance is 100 ohms for zones 1 and 8, and 300 ohms for all other zones (excluding the
2K EOL resistor).
ULC
Smoke detector devices have not been evaluated for ULC installations.
To wire burglary and panic devices to zones 1-9, connect sensors/contacts to the hardwire zone terminals (10 through
23). See
Figure 3-9 . Connect N.C. and N.O. devices as follows:
•
Connect N.C. devices in series with the high (+) side of the loop. The 2K EOL resistor must be connected in series
with the devices, following the last device.
•
Connect N.O. devices in parallel (across) the loop. The 2K EOL resistor must be connected across the loop wires
at the last device.
+ +
-
N.C. N.C.
N.O.
2k EOLR 2k EOLR
+ -
+ +
-
N.C. N.C.
2k EOLR 2k EOLR
+ +
-
N.C.
+ + -
N.C.
N.C.
2k EOLR
SMOKE
Zone resistance (Excluding EOLR):
ZONE 1,8: 100 OHMS MAXIMUM
ALL OTHER ZONES: 300 OHMS MAXIMUM
ZONE 1
ZONE 2 ZONE 3 ZONE 4 ZONE 5 ZONE 6 ZONE 7 ZONE 8 ZONE 9
2-WIRE SMOKE DETECTOR LOOP
(Also supports NO/NC Burg contacts)
10 11 12 13 14 15 16 17 18 19 20 21 22 23
N.C.
N.O.
N.O. N.O.
2k EOLR
N.O. N.O.
N.O.
N.C.
N.O.
2k EOLR 2k EOLR
N.C.
Fire
Usage
Burg.
Usage
Red Jumper
Zone response time:
ZONES 1-9: 350mSec-500mSec
hw-zones-002-V1
Figure 3-9: Wiring Connections for Zones 1-8