MORLEY-IAS
ZX Fire Alarm Control Panels
Page 50
Document No. 996-175-000-1, Revision 01
Commissioning Manual
Network Option
Option setting
Comments
Panel network-address
number
1 to 99
Enter Master’s own address, e.g.. 4.
Quantity of slave
processors
1 to 99
Number of slaves DIRECTLY connected to the Master, i.e.
via port C.
Slave CPU 1 is at
network address
1 to 99
The address of the first slave panel.
Slave CPU 2 is at
network address
1 to 99
The address of the second slave panel.
Etc.
Use modem
[TRUE]/[FALSE]
Set to TRUE if a modem is connected to port C.
Share zones
[TRUE]/[FALSE]
Zones are shared between panels
Peer-to-Peer [TRUE]/[FALSE]
Allow
MUTE
/ ACCEPT, SILENCE / RESOUND and RESET
key presses from a slave panel.
Port B Protocol *
0
Use default of 0 unless special applications interface.
System events
[GLOBAL]/[LOCAL]
Global -
1.
Passes system events over network
2.
Accepts other network events
Local -
1.
Does not pass events over the network.
2.
Ignores other network events
NOTE: The zoned fire status is passed over a shared-zone
network regardless of events being global or local.
Table 13 – Master Panel Network Settings
For full information on how to commission and program a network installation, refer to
document P/N 996-075.
13.2 Port B Protocols
NOTE: * Port B Protocol is not available on ZX1Se or ZX2Se panels.
•
The Port B serial interface supports a number of different protocols.
•
These can be used to define the connections as:
1. Standard MORLEY-IAS Panel Network / Graphics PC Interface
2. Pager
Interface
3. Other PC System Interface
•
The following table defines the settings to be entered for each interface type.
