ZX Fire Alarm Control Panels
MORLEY-IAS
Commissioning Manual
Document No. 996-175-000-1, Revision 01
Page 1
1 Introduction
1.1 Notice
•
The material and instructions covered in this manual have been carefully checked for accuracy and
are presumed to be correct. However, the manufacturer assumes no responsibility for inaccuracies
and reserves the right to modify and revise this document without notice.
•
These instructions cover the programming of the Fire Alarm Control
Panel. Refer to the Installation Manual (P/N 996-174-000-X) for
details of how to install the system and refer to the User Manual
(P/N 996-182-000-X) for information on operation and use of the
panel.
•
If System Sensor / Morley-IAS / Honeywell Multi-sensor or Laser devices are incorporated into your
installation, ensure that you have the current Universal Loop Driver card appropriate to the protocol
you are using. If you have any doubt as to the correct version to fit, please contact Technical Support.
•
The ZX1Se, ZX2Se, ZX5Se and ZX10Se Fire Alarm Control Panels are 1, 1-2, 1-5 and 1-10 loop panels
for use with analogue addressable devices from the following detector manufacturers’ ranges:
Apollo
S90
Hochiki
Morley-IAS
Nittan
System Sensor
EN54
!
EN54-2
Nittan
The ZXSe Range of Fire Alarm Control Panels have not been
independently tested and certified as complying with the
requirements of EN54-2 when used with the Nittan range of
signalling devices.
If the Nittan loop driver card is installed, the LPCB logo MUST be
removed.
1.2 Warnings and Cautions
These instructions contain procedures to follow in order to avoid injury and damage to
equipment. It is assumed that the user of this manual has been suitably trained and is
familiar with the relevant regulations.
All equipment is to be operated in accordance with the appropriate standards applicable
For use with software
version 834 onwards
