ZX Fire Alarm Control Panels
MORLEY-IAS
Commissioning Manual
Document No. 996-175-000-1, Revision 01
Page 15
5 Configure
Option
5.1 Accessing the Configure Option
•
Page 1 of the Commission menu is shown below:
[ Panel in Commissioning mode ]
----------------------------------------------
1)CONFIGURE YES)More Options
[1]
2)Inspect 3)NORMAL OPERATION
•
The CONFIGURE option allows the Signalling Loops, peripherals, sounders and relays to be
programmed. It also enables the function to allow the panel to be programmed by a PC.
•
Press ‘1’ to select the ‘CONFIGURE’ option.
The CONFIGURE option and all sub menu options require the Memory Lock to
be open.
•
The display then shows a menu of options as follows:
[ Panel in Commissioning mode ]
----------------------------------------------
CONFIGURE : Loop 1) 2) 3) 4) 5)
[1]
6)Peripherals 7) Sounders 8)Relays 9)PC
NOTE: The menu will only show the number of signalling loops programmed during setup (Refer to the Setup
Option). The ZX2Se can only have two loops maximum.
5.2 Signalling
Loops
•
After selecting a loop from the configure menu, the display will present a list of options as follows:
[ Panel in Commissioning mode ]
----------------------------------------------
CONFIGURE : Loop 1) 1)Zones
[1]
2)Devices 3)Auto Learn 4)Calibrate
The words ‘CONFIGURE: Loop 1’ on the top line of the menus provides a reminder that
panel is in configuration mode, with loop 1 selected.
•
Select the required option by pressing the appropriate numeric key.
•
When commissioning a new panel, start by performing an ‘Auto Learn’. This will cause the panel to
search for all devices installed on the loop.
