Honeywell HVAC232 Series, Applications Manual

Page: 53 / 145

Application manual HVAC232/402 | Document 27-652 | Issue ENG06 | 2019-08-07 53
8.4 Parameter menu
In Parameter menu only the Quick setup parameter list is shown as default.
By giving the value 0 to the parameter 17.2, it is possible to open other
advanced parameter groups. The parameter lists and descriptions can be
found in „9
Standard application parameters“ on page 55 and „10
Parameter description“ à la page 96.
The following figure shows the parameter menu view:
OK
OK
OK
FAULT ALARM STOP READY RUN
REF
MON
PAR
SYS
REF
MON
PAR
SYS
REF
MON
PAR
SYS
FAULT ALARM STOP READY RUN
FAULT ALARM STOP READY RUN
S U B D A P Y E K O /I V E R D W F S U B D A P Y E K O /I V E R D W F
FWD R EV I/O KEYPAD BUS
FAULT ALARM STOP READY RUN
REF
MON
PAR
SYS
FWD R EV I/O K EYPAD BUS
FAULT ALARM STOP READY RU N
REF
MON
PAR
SYS
FWD R EV I/O KEYPAD BUS
Hz
1
2
4 3
6
5
Press Right to browse
other Parameter group.
Press OK button
to enter edit mode
Press OK to enter to
the parameter menu
Press Down button
to browse P3.4
Press OK to confirm
Press Up/Down to change value
Fig. 41. Parameter menu
The parameter can be changed as the Figure „Fig. 41. Parameter menu“ on
page 51.
Left / Right button is available inside Parameter menu. Pressing Left /
Right button to change the actual parameter to the first parameter of the
next group (Example: any parameter of P1… is displayed -> RIGHT button ->
P2.1 is displayed -> RIGHT button -> P3.1 is displayed …). After entering the
desired group, pressing UP / DOWN button to select root parameter num-
ber, and then press OK button to display the value of the parameter and also
enter edit mode.
In edit mode, Left and Right buttons are used to select the digit which has
to be changed, and Up increases / Down decreases parameter value.
In edit mode, the value of Px.x is displayed blinkingly in the panel. After
about 10 s, Px.x is displayed in the panel again if you don't press any button.
NOTE:
In edit mode, if you edit the value and don't press OK button, the
value isn't changed successfully.
NOTE:
In edit mode, if you don't edit the value, you can press Reset /
Back button to display Px.x again.